Clip SN40 is designed to snap into position on your vehicle, the clip is designed to be smaller than the casting of the factory caliper for a snug fit.
* The first step is to engage the bottom clip leg on the casting of the carrier bracket on the side closest to the rotor.
* Rotate the clip towards the top of the caliper and push into position or until the clip clicks into place
* The design of the clip may require a bit more than just a hand push, using a rubber mallet to tap it into position may be necessary
Below you will see images of this exact installation for your review, showing the correct spot and angle the clip needs to be mounted on.
